instruction manual

PRO FANCY LEDS

Follow the steps carefully to ensure you correctly set up your Pro Fancy LEDs. Consult the FAQ below this if you have more questions.

Instructions

Please follow all steps, especially Step 5 regarding the peeling of double sided tape.

Step 1 - Planning

Be sure to measure the length of the area you want to install the Fancy LEDs on. We recommend having LED lights start vertically up your wall, but if you prefer to start the line horizontal from the top of your wall, you will need additional accessories to hold the power supply and white control box against the wall. Otherwise, the LEDs may be pulled off the wall due to the weight of attachments.

Step 2 - Cleaning

Clean the surface you will be applying sticking you LED lights onto, until it is free of dust and dirt. This will allow adhesive to stick & hold strongly.

Step 3 - POWER

Connect your white control box to the power supply. Connect your power supply to the power point.

Step 4 - CONNECT

Next, connect the remote receiver to the lights with the 4-pin connector. Making sure the small arrows on the LED connector and white control box connector are ARROW TO ARROW. If you are connecting a 49.2ft or 65.6ft DO NOT connect the LEDs into one length.

Attach 2 x Rolls together and connect into the adaptor, arrow to arrow. Repeat with remaining 2 x rolls or single roll by connect this to the last connection on the adaptor.

Step 5 - ADHESIVE

Carefully peel back the thin plastic film off the double-sided tape on the back of the LED strip to reveal the adhesive. Make sure you are peeling only the adhesive backing from the strip and not pulling the entirety of the tape, including the adhesive, off the LED strips. If you notice the strip is not sticky, it means you are removing the double-sided tape entirely.

Step 6 - CORNERS

Do not bend the LED strip to a 90-degree angle around corners to make them flush as this may damage the circuitry of the LEDs. Rather gently curve the LEDs around the corners.

Step 7 - CHECKS

Once all steps are completed, press firmly along the LED strip to assist the adhesive in attaching to your wall. Leave the LED adhesive to dry for 3 minutes before turning on, as the heat of the LED lights may weaken the bond of the adhesive to the wall.

Now point your remote at the IR receive and your ready to go!

Need Help?

If you are unsure, please contact support via help@fancyleds.com or refer to the FAQ page. Note, damage caused by user error may result in the warranty being void.

Need Help

HAVE A QUESTION?

Feeling unsure? Always consult the FAQ page or contact us.

LED Light strips viral on TikTok and Instagram

Subscribe to our newsletter

Promotions, new products and sales. Directly to your inbox.

Free shipping

Free shipping to the USA, UK, AUS/NZ & some European countries